5
PRE-OPERATION PROCEDURES
5.8
PING Test
This section describes the PING test.
The PING test is used to check the existence of other devices on the same Ethernet (the
same subnet address).
(1) How to execute the PING test
5
- 23
5.8 PING Test
(a) From Utility Package
1) Double-click "Ping Test" on the selection tree to display the window below.
Figure 5.22 "Ping Test" window
2) Set the following items.
Table 5.10 Setting items on the "Ping Test" window
Item
Nic No.
Communication Time Check
Transmission Count
IP Address
3) Click the
Ping Test
4) Check the displayed test results.
Table 5.11 Test results shown in the "Ping Test" window
Item
Total Packet Transmission Count
Success Count
Failure Count
Select the module (Nic1 to 4) to be subjected to the PING test.
Set the time period to wait for completion.
Set the transmission counts.
Enter the IP Address of the target device.
button to execute the test.
After the PING test is completed, the total packet transmission
count is displayed.
After the PING test is completed, the number of PING test
successes is displayed.
After the PING test is completed, the number of PING test
failures is displayed.
Description
Description