Mitsubishi Electric MELSEC Q Series User Manual page 187

7
UTILITY PACKAGE (SW1DNC-EIPUTL-E)
Item
Upload
(3) Precautions
Note the following points when reading the parameters in the EtherNet/IP module into
Utility Package.
Table 7.28 Description of the "Upload Parameter" window (Continued)
Reads out the parameters of the EtherNet/IP module.
Item
All checkboxes are selected.
button
All Select
All checkboxes are cleared.
button
Clear
When they are selected, the settings made in the
Refresh Parameter "Refresh Parameter" window are read from the
CPU module.
The IP address data that have been set in the
Nic No.1 to 4 IP
"Add Own Nic" window are read from the
Address
EtherNet/IP modules with the selected Nic Nos.
The settings made on the "Setting" tab are read
Nic No.1 to 4 Tag
from the EtherNet/IP modules with the selected
Parameter
Nic Nos.
The selected parameters are read from their
button
Upload
respective EtherNet/IP modules.
Deletes the settings of "Upload Parameter".
button
Cancel
• Among Data Type registered in the "User Define" window, those not being used
by parameters are not written into the EtherNet/IP module.
Therefore, unused Data Types are deleted when parameters written in the
EtherNet/IP module are read into Utility Package.
To save the Data Types that are not used by parameters, save the project file
(*.eip).
• Note that parameters that have been set in the "Refresh Parameter" window may
be read as parameters that have been set by each tag. (When the number of
auto refresh settings is four or less and the refresh size is the same as the total
size of the Tags)
To save the settings made in the "Refresh Parameter" window, save the project
file (*.eip).
7.10.3 Reading out parameters of the EtherNet/IP module
Description
Description
Reference
section
-
7
7.10 Online
- 60
1
2
3
4
5
6
7
8