Mitsubishi Electric MELSEC Q Series User Manual page 132

7
UTILITY PACKAGE (SW1DNC-EIPUTL-E)
(Start)
Double-click
(To the next page)
7
- 5 7.2 Installing and Uninstalling
7.2.1 Installing
1.
Start Windows Explorer and open the drive where the disk is
loaded.
Double-click "setup.exe".
When using Windows Vista
User Account Control is enabled.
Select "Allow".
When using Windows
User Account Control is enabled.
Click the button.
Yes
2.
When the window shown on the left appears, click
and uninstall Utility Package. And then install it all over again.
Utility Package may not operate properly if the installation is
executed without uninstallation.
, the below window is displayed if
7, the below window is displayed if
Cancel