X200-X202 Drive-Cliq Interfaces; X2 Braking Resistor Connection - Siemens SINAMICS S120 Equipment Manual

Line Modules Booksize
3.4 Basic Line Modules with internal air cooling
3.4.3.5

X200-X202 DRIVE-CLiQ interfaces

Table 3-27 DRIVE-CLiQ interface X200-X202
PIN
1
2
3
4
5
6
7
8
A
B
Blanking plate for DRIVE-CLiQ interface: Yamaichi, order no.: Y-ConAS-13
3.4.3.6

X2 braking resistor connection

Table 3-28 Terminal block X2 on Basic Line Module (20 kW)
Terminal
1
2
Table 3-29 Terminal block X2 on Basic Line Module (40 kW)
Terminal
1
2
196
Signal name
TXP
TXN
RXP
Reserved, do not use
Reserved, do not use
RXN
Reserved, do not use
Reserved, do not use
+ (24 V)
M (0 V)
Designation
Braking resistor connection R
Designation
Braking resistor connection R
Technical specifications
Transmit data +
Transmit data -
Receive data +
Receive data -
24 V power supply
Electronics ground
Technical specifications
Max. connection voltage:
480 V 3 AC +10 % at 47 Hz to 63 Hz
Max. connectable cross-section: 4 mm
Type: Screw terminal 5 (see Connection systems)
Tightening torque: 0.5 - 0.6 Nm
Technical specifications
Max. connection voltage:
480 V 3 AC +10 % at 47 Hz to 63 Hz
Max. connectable cross-section: 10 mm
Type: Screw terminal 6 (see Connection systems)
Tightening torque: min 1.5 - 1.8 Nm
Equipment Manual, (GH2), 07/2007, 6SL3097-2AC00-0BP5
2
2
Booksize Power Units