Installation And Adjustment Of Mirrors And Camera - Komatsu PC130-8 Shop Manual

30 Testing and adjusting
Installation and adjustment of
mirrors and camera
Serial No.: 80001 - 84235
1. Installation of retractable mirrors
Install retractable mirrors (a1) and (b1) as
shown in the figure.
Retractable mirror (a1): Install at 20 mm
q
(from the bottom of the intermediate stay).
Install mirror stay (1) so that the mirror will
be fixed at (A) of the 3 stopping positions
where the mirror is extracted most and at
an angle of about 73° to the intermediate
stay.
a If the mirrors are not installed to the cor-
rect positions, they may interfere with the
exterior parts.
PC130-8
Tightening torque of mirror bolt (2):
1
Tightening torque of mirror stay bolt (3):
a If the tightening torque is low, the bolts
may be dragged. If the former is too high,
the body may be broken.
Retract the mirror into position (C) when
transporting the machine.
Retractable mirror (b1): Install at 65 mm
q
(from the top of the stay). Install mirror
stay (4) so that the mirror will be fixed at
(A) of the 3 stopping positions where the
mirror is extracted most and at an angle of
about 19° to the side of the machine body.
a If the mirrors are not installed to the cor-
rect positions, they may interfere with the
exterior parts.
SEN04114-06
4.0 – 5.4 Nm {0.41 – 0.55 kgm}
15 Nm {1.52 kgm}
59