Failure Code [Ca451] Rail Press. Sensor High Error - Komatsu PC130-8 Shop Manual

Hydraulic excavator

Hide thumbs Also See for PC130-8:

Table of Contents

Failure code [CA451] Rail press. sensor high error

Failure code

• High voltage was detected in common rail pressure sensor circuit.

• Limits output and continues operation (Limits common rail pressure).

Problem that

• Output drops.

• Signal voltage of common rail pressure sensor can be checked with monitoring function.

(Code: 36401 Common rail pressure sensor voltage)

• Method of reproducing failure code: Turn starting switch ON.

Defective sensor power sup-

Defective common rail pres-

(Internal trouble)

Possible causes

Disconnection in wiring har-

and standard

value in normal

(Disconnection in wiring or

defective contact in connec-

Ground fault in wiring har-

(Short circuit with GND cir-

Rail press. sensor high error

(Engine controller system)

Standard value in normal state/Remarks on troubleshooting

If failure code [CA352] or [CA386] is indicated, carry out trouble-

shooting for it first.

a Prepare with starting switch OFF, then turn starting switch ON

or start engine and carry out troubleshooting.

Between (3) – (1)

Between (2) – (1)

Sensor voltage is measured with wiring harness connected.

Accordingly, if voltage is abnormal, check wiring harness and con-

troller, too, for another cause of trouble, and then judge.

a Prepare with starting switch OFF, then carry out troubleshoot-

ing without turning starting switch ON.