Retraction In The Tool Direction (Jog Retract); Overview - Siemens SINUMERIK 840D sl Function Manual

● The current axis positions are:
– X axis: 10
– Y axis: 10
● The axes are homed.
Parameter assignment
SD42690 $SC_JOG_CIRCLE_CENTRE[AX1] = 10Center of circle X axis to position 10 mm
SD42690 $SC_JOG_CIRCLE_CENTRE[AX2] = 20Center of circle Y axis to position 20 mm
SD42691 $SC_JOG_CIRCLE_RADIUS = 20
SD42692 $SC_JOG_CIRCLE_MODE = 2
SD42693 $SC_JOG_CIRCLE_START_ANGLE = 0No start angle active
SD42694 $SC_JOG_CIRCLE_END_ANGLE = 0 No end angle active
Result
Circle inside machining takes place.
With continuous traversing of the X axis using the plus traversing key, a counter-clockwise
(G2) circular movement can be initiated with a radius of 10 mm about the center point of the
circle (10, 20).
With the traversing of the Y axis, the circle radius can be changed between 0.02 and 19.98.
4.12

Retraction in the tool direction (JOG retract)

4.12.1

Overview

Function
The function "Retraction in the tool direction with the machine function JOG retract", called
"JOG retract" in the following, supports the manual tool retraction in the workpiece coordinate
system (WCS) after a program abort through a power off of the control or a channel reset in
the AUTOMATIC or MDI mode.
Extended Functions
Function Manual, 10/2015, 6FC5397-1BP40-5BA3
H1: Manual and handwheel travel
4.12 Retraction in the tool direction (JOG retract)
Circle radius 20 mm
Traversing with the plus key:
traversing the circle counter-clockwise
Consideration of the tool radius compensa‐
tion
Internal machining
207