NEC Express5800/R320g-E4 Installation Manual page 37

Chapter 1 Installing Operating System
– Follow the steps below when enabling an SSH connection to the ESXi host.
1. Select [Troubleshooting Options] and press Enter.
2. Select [Enable SSH] and press Enter to change the setting from [SSH is Disabled] to [SSH is Enabled].
3. Press ESC to return to the [System Customization] menu.
Press ESC to log out.
Important Do not change the network configuration that is created at installation of the ESXi
host before the setup procedure described in this guide completes.
If you need to add standard switch, perform it after setup process completes.
Set [Configuration Management Network] and [Troubleshooting Options] according to your
Note
environment.
If IPv6 is disabled in Configure Management Network, the system reboots automatically.
Tips
Express5800/R320g-E4, R320g-M4 Installation Guide (VMware)
1. Setup Procedure
37