Precautions For Changing The Configuration After Setup; If The Network Settings Of The Esxi Host Or Root User Password Has Been Changed - NEC Express5800/R320g-E4 Installation Manual

Chapter 1 Installing Operating System
2.3

Precautions for Changing the Configuration after Setup

If the network configuration has been changed after completing the setup, run the following command.
If the network settings of the ESXi host or root user password has been
changed
The process that runs on ftSys Management Appliance manages duplication by connecting with ESXi host.
If IP address or hostname of ESXi host, root user password has been changed, the process running on ftSys
Management Appliance will be unable to login to ESXi host.
1. Log in to ftSys Management Appliance as a root user.
2. Run the configure-appliance command. Then, enter the IP address or hostname of ESXi host, root
user name, and root user's password.
# /opt/ft/sbin/configure-appliance
3. After running the command, reboot ftSys Management Appliance.
Restart the virtual machine from Host Client, or run the following command.
# shutdown -r now
66
Important Configuration should be changed after setup is complete. If the configuration is
changed during setup, it can cause an unexpected behavior.
Note Execution example: When the IP address of log server is 192.168.0.7:
# /opt/ft/sbin/configure-appliance
Enter Name or IP address of the host ftServer, [192.168.0.7]:
Enter Administrative user for 192.168.0.7, [root]:
Enter Administrative password for 192.168.0.7 []:
All entries have been removed successfully.
Created user ftsysuser successfully.
:
configure-appliance: Verifying permissions on the host system
:
Multiple paths to storage
Network Configuration
Host ftSys service started
Host logs available after reboot
DNS Configuration
Express5800/R320g-E4, R320g-M4 Installation Guide (VMware)
2. Procedures after Completion of Installation
Perform the following settings
[PASS]
[PASS]
[PASS]
[PASS]
[PASS]