NEC Express5800/R320g-E4 Installation Manual page 54

Chapter 1 Installing Operating System
54
With the ftSys Management Appliance, clock synchronization cannot be done using NTP.
Note
The ftSys Management Appliance performs clock synchronization with the ESXi host at
intervals of 1 min by using VMware Tools.
You must not change the below setting because it is set by installation of the ft control
software.
1. Right-click on the ftSys Management Appliance in Host Client.
2. Click "Edit Settings" in the right-click menu.
3. On the [VM Options] tab, select [VMware Tools]
4. Confirm that the [Time] - [Synchronize guest time with host] check box is on.
If you need accurate clock management with the ftSys Management Appliance, set up NTP
Tips
on the ESXi host. If accurate clock management is active with NTP on the ESXi host, clock
management more accurate than that by the ftSys Management Appliance is achieved by
the VMware Tools clock synchronization function specified in Note above.
Note When ESXi operates, the following alert message may appear on the console screen. This
message does not affect the operation, and you can ignore it. If this message appears,
press the <Alt + F2> key to switch the console screen.
Express5800/R320g-E4, R320g-M4 Installation Guide (VMware)
1. Setup Procedure