NEC Express5800/R320g-E4 Installation Manual page 52

Chapter 1 Installing Operating System
10. Input the host name or IP address of the ESXi host, and press the <Enter> key. Input the root password
of the ESXi host, and press the <Enter> key.
Name or IP address of the host machine[]:
Administrative password for xxx.xxx.xxx.xxx:
11. The confirmation message appears. Input "Y".
Please refer to your system documentation before proceeding.
Do you want to continue [Y/n]: _
12. The confirmation message appears again. Input "Y".
Do you want to continue? [Y/n]: _
13. The following message appears, and the installation starts. (The message may be partially different
depending on your environment.)
Installing to host xxx.xxx.xxx.xxx. Please wait...
Setting claimrule 119 for driver ftSys_msgpt3 to use NMP
Updating the host's system software...
Deactivating port 80 for host upgrades
14. As the installation is finishing, the confirmation message for restarting appears. Input "Y". Check that the
ESXi host has shut down, and remove the ft control software installation DVD.
A host reboot is required to place these updates into service.
Do you want to reboot now [Y/n]: _
15. The system reboots, and the module registration for ft server and disk duplication are performed. These
processes take several tens of minutes.
52
You can configure the DNS server after completion of installation.
Tips
Note The result of the task may be displayed as failed on the host client as shown below. You
can ignore this because it does not affect operation.

Note The time required for completing the duplication varies depending on the disk space.

The system will reboot twice if ft control software is installed in internal hard disk drive.

The disk duplication is not performed if FT control software is installed in an external
storage.
Express5800/R320g-E4, R320g-M4 Installation Guide (VMware)
1. Setup Procedure