Connecting And Configuring Options - NEC Express5800/R320g-E4 Installation Manual

Chapter 1 Installing Operating System
1.11

Connecting and Configuring Options

If there is any optional PCI board or peripheral equipment to connect to NEC Express5800/ft series, turn off the
power to NEC Express5800/ft series, and connect it according to Chapter 2 (5.7 PCI Card) in Maintenance Guide
and the device's instruction.
For how to install and use hard disk drive, see Chapter 2 (2. Hard Disk Drive Operations) in Maintenance Guide.
Immediately after the installation completes, network configuration for a port is duplicated. When you change the
network configuration or configure the duplication setting by adding a LAN card, it is necessary to configure the
settings from Host Client.
For detailed procedures, refer to VMware vSphere documents from the following Website.
https://docs.vmware.com/en/VMware-vSphere/index.html
* The contents of this web site is subject to change or delete without notice.
For how to add LAN cards or configure the duplicated network, see Chapter 2 (5.7 PCI Card and 3. Duplex LAN
Configuration) in Maintenance Guide.
To have enough time to initialize Fibre Channel disk and Fibre Channel switch and so on, adjust [Server] - [Power
On Delay Time] by setting System BIOS configuration Utility.
Express5800/R320g-E4, R320g-M4 Installation Guide (VMware)
1. Setup Procedure
59