1.1.1 Preinclination - NEC Express5800/R320g-E4 Installation Manual

Chapter 2 Installing Bundled Software

1.1.1 Preinclination

SNMP is used for reporting to NEC ESMPRO Manager. Provide settings for SNMP as shown below.
1. Log in to ftSys Management Appliance as a root user.
2. Edit the /etc/snmp/snmpd.conf.
Change the /etc/snmp/snmpd.conf, and, for ESMPRO MIB (.1.3.6.1.4.1.119.2.2.4.4), set a right of the
community in "READ WRITE".
In the example below, "READ WRITE" authority is given to all MIB (.1 subordinates) of default
community (public).
Example
####
# Third, create a view for us to let the group have rights to:
# name incl/excl subtree mask(optional)
#view systemview included .1.3.6.1.2.1.1
#view systemview included .1.3.6.1.2.1.25.1.1
view all included .1 80
####
# Finally, grant the group read‐only access to the systemview view.
# group context sec.model sec.level prefix read write notif
#access notConfigGroup "" any noauth exact systemview none none
access notConfigGroup "" any noauth exact all all none
3. Check that enabled of snmpd.
# systemctl is-enabled snmpd.service
enabled
- In case of enabled, restart snmpd.
# systemctl restart snmpd.service
- In case of disabled, change the setting of snmpd, and start snmpd.
# systemctl enable snmpd.service
# systemctl start snmpd.service
4. Allow to receive the snmp/udp port on the ft management appliance.
# firewall-cmd --permanent --add-rich-rule='rule family="ipv4" port
port="161" protocol="udp" accept'
# firewall-cmd --reload
72
Note Refer to Help of snmpd.conf for detailed procedure. Run man command to open Help of
snmpd.conf.
Express5800/R320g-E4, R320g-M4 Installation Guide (VMware)
1. Bundled Software for the Server
Modify these lines.
– Comment out the existing
description.
– Add new descriptions.