Backing Up System Information; Bios Setup - NEC Express5800/R320g-E4 Installation Manual

Chapter 1 Installing Operating System
1.13

Backing up System Information

We recommend you to back up the system information after setting up the system.
With backup for system information, the information and settings that are specific to your server can be restored
after the server is repaired. Follow the steps below to dictate the system information:

BIOS SETUP

1. Power on the server, and run POST.
2. Press F2 while the following message is displayed on the screen.
Press <F2> SETUP, <F4> ROM Utility, <F12> Network
3. When POST completes, write down the new setting values.
< Example >
[Advanced] - [PCI Configuration] - [PCI Device Controller and Option ROM Settings]
- [SAS Option ROM Scan]
- [PCIx Slot Option ROM]
[Security]
[Server] - [OS Boot Monitoring]
[Server] - [Power Control Configuration]
- [AC-LINK]
- [Power On Delay Time]
[Boot] - [Boot Option Priorities]
4. Select Save changes and Exit.
On the confirmation window shown below, select [Yes].
Save configuration and exit?
Then, the server will restart.
Express5800/R320g-E4, R320g-M4 Installation Guide (VMware)
1. Setup Procedure
61