Table of Contents
Advertisement
FusionModule2000 Smart Modular Data Cente
Maintenance Guide
2.
----End
6.1.2 Synchronizing the Configuration Parameters
Procedure
Step 1 After replacing components, log in to the ECC800 WebUI and choose Maintenance >
Parameter Sync to access the parameter synchronization page.
Step 2 Click Device type and select the component type from the drop-down list.
Step 3 Select the failure device in Source Device, select the reserved device in Target Device, and
click Submit to synchronize the configuration parameters of the failure device to the reserved
device.
----End
6.2 Replacing Power Supply and Distribution System
Components
6.2.1 Parts Replacement for the Precision PDC
For details about parts replacement for the precision PDC, see the "Parts Replacement"
section in the corresponding Precision PDC user manual.
Table 6-2 Replaceable parts of the precision PDC
No.
1
2
3
4
5
6
Issue 03 (2019-12-04)
On the login page, enter the preset user name admin and preset password Changeme,
set the language, and click Log In.
After the first login, change the password in time to ensure account security and prevent
unauthorized network attacks, such as data tampering. Huawei will not be liable for any security
issues caused by your failure to change the preset password in time or password loss after changing.
An account is logged out due to timeout if no operation is performed within 10 minutes after system
login.
It is recommended that a maximum of three users log in to the ECC800 WebUI at the same time.
Copyright © Huawei Technologies Co., Ltd.
Replaceable Part
MCB (Miniature circuit breaker)
MDU (Monitor display unit)
SPD (Surge protective device)
Fuse
Indicator
Power distribution detection module
6 Parts Replacement
38
Advertisement
Table of Contents
