Parts Replacement For The Access System; Replacing An Access Actuator - Huawei FusionModule2000 V500R002C03 Maintenance Manual

FusionModule2000 Smart Modular Data Cente
Maintenance Guide
Figure 6-18 Removing a camera
Step 3 Remove the monitoring network cable from the camera and remove the camera.
Step 4 Install the new camera. Then, set parameters and commission the camera according to the
commissioning guide.
Step 5 Verify that the camera is normal.
----End

6.4.3 Parts Replacement for the Access System

6.4.3.1 Replacing an Access Actuator

Impact on the System
The aisle access control system cannot be used.
Preparations


Procedure
Step 1 Label each cable based on the corresponding ports on the access actuator.
Step 2 Disconnect cables from the access actuator.
Step 3 Remove the failure access actuator from guide rails.
Issue 03 (2019-12-04)
Tools: ESD wrist strap, ESD gloves, Phillips screwdriver, step ladder, labels, marker
Material: access actuator
Copyright © Huawei Technologies Co., Ltd.
6 Parts Replacement
55