Parts Replacement For The Access System; Replacing An Access Actuator - Huawei FusionModule2000 Maintenance Manual

FusionModule2000 Smart Modular Data Center
Maintenance Guide (Fusion Module Actuator)
Figure 5-33 Removing the camera
Step 4 Install the new camera and SD card. Then, set parameters and commission the
camera according to the commissioning guide.
Step 5 Check that the camera functions properly.
----End

5.4.3 Parts Replacement for the Access System

5.4.3.1 Replacing an Access Actuator

Impact on the System
The aisle access control system cannot be used.
Preparations
●
●
Procedure
Step 1 Label each cable based on the corresponding ports on the access actuator.
Step 2 Disconnect cables from the access actuator.
Step 3 Remove the failure access actuator from guide rails.
Issue 01 (2020-12-25)
Tools: ESD wrist strap, ESD gloves, Phillips screwdriver, step ladder, labels,
marker
Material: access actuator
Copyright © Huawei Technologies Co., Ltd.
5 Parts Replacement
85