Huawei FusionModule2000 Maintenance Manual page 86

FusionModule2000 Smart Modular Data Center
Maintenance Guide (Fusion Module Actuator)
Prerequisites
●
●
●
●
Context
Recommended tools and materials: Phillips screwdriver, ESD wrist strap (or ESD
gloves).
Procedure
Step 1 Put on an ESD wrist strap (or ESD gloves) and insert the ground terminal into the
ESD jack in the cabinet.
Step 2 Remove the faulty hard disk.
1.
2.
3.
Figure 5-22 Removing a hard disk
Step 3 Install a new hard disk.
1.
2.
3.
4.
Issue 01 (2020-12-25)
The hard disk needs to be replaced.
Data in the hard disk has been backed up.
A spare hard disk of the same model is available and functional.
Before replacing a faulty disk, ensure that the power switch on the rear panel
is off and disconnect the power cable to power off the device.
Press the button on the hard disk panel to open the ejector lever.
Pull out the hard disk for about 3 cm, wait for 30 seconds at least until the
hard disk stops rotating, and pull it out.
Use a screwdriver to loosen the screws from the hard disk and remove the
hard disk.
Install the new hard disk.
Secure the hard disk to the front panel using a screwdriver.
Push the hard disk into the subrack along the guide rails until it cannot move
forwards.
Close the ejector lever and push the hard disk in position.
Copyright © Huawei Technologies Co., Ltd.
5 Parts Replacement
79