Replacing An Elight Strip Light - Huawei FusionModule2000 Maintenance Manual

FusionModule2000 Smart Modular Data Center
Maintenance Guide (Fusion Module Actuator)

5.4.23 Replacing an eLight Strip Light

Impact on the System
The eLight strip light is off during replacement.
Preparations
●
●
Procedure
Step 1 Remove three white rubber panels from the door frame.
Step 2 Remove the side covers from the posts.
Step 3 Cut off the cable tie that binds the strip light extension cable to the top of the
post.
Step 4 Pull the strip light out of the bottom of the left post.
Step 5 Disconnect the strip light terminal from the strip light extension cable of the door
post.
Step 6 Pull out the strip light from the fasteners.
Figure 5-83 Removing a strip light
(1) Strip light extension cable
Issue 01 (2020-12-25)
Tool: ESD gloves
Material: eLight strip light
Copyright © Huawei Technologies Co., Ltd.
(2) Strip light extension cable
5 Parts Replacement
127