Replacing The Vcn510 Hard Disk - Huawei FusionModule2000 Maintenance Manual

FusionModule2000 Smart Modular Data Center
Maintenance Guide (Fusion Module Actuator)
After removing cables, wrap exposed terminals with insulation tape and do not
block cable labels. If cable labels are blocked, cables may be connected incorrectly.
Step 2 Remove the faulty VCN510 from the cabinet.
Step 3 Carry the device to the cabinet. Ensure that the mounting ears at both sides of the
device are tightly attached to the mounting bars in front of the cabinet. Use one
hand to hold the device. Use the other hand to thread M6 screws through the
slotted holes on the mounting ears. Use a Phillips screwdriver to tighten the M6
screws on the mounting ears. Each mounting ear uses two M6 screws.
Figure 5-11 Installing the device
Step 4 Reconnect the cables to the new VCN510.
Step 5 Turn on the power switch of the VCN510.
Step 6 Commissioning the VCN510. If the video recording function works properly after
commissioning, the VCN510 is functional.
----End

5.4.2.2 Replacing the VCN510 Hard Disk

Prerequisites
●
●
●
●
Issue 01 (2020-12-25)
NO TICE
The hard disk needs to be replaced.
Data in the hard disk has been backed up.
A spare hard disk of the same model is available and functional.
Before replacing a faulty disk, ensure that the power switch on the rear panel
is off and disconnect the power cable to power off the device.
Copyright © Huawei Technologies Co., Ltd.
5 Parts Replacement
71