Huawei FusionModule2000 Maintenance Manual page 100

FusionModule2000 Smart Modular Data Center
Maintenance Guide (Fusion Module Actuator)
2.
3.
Issue 01 (2020-12-25)
Figure 5-43 Removing a magnet
(Optional) Insert the positioning pins of the magnet into the magnet using a
rubber mallet, as shown in
Figure 5-44 Installing positioning pins of a magnet
Insert the assembled magnet into the magnetic lock base on the revolving
door, and secure the magnet to the door using the screws on the door and
the white rubber washer delivered with the magnet, as shown in
NO TE
When securing the magnet to the door panel, do not over-tighten the screws so that
the white rubber washer is elastic. The washer will adjust the magnet to a correct
position because of its elasticity.
Copyright © Huawei Technologies Co., Ltd.
Figure 5-44.
5 Parts Replacement
Figure 5-45.
93