Replacing A Cabinet Electronic Lock - Huawei FusionModule2000 Maintenance Manual

FusionModule2000 Smart Modular Data Center
Maintenance Guide (Fusion Module Actuator)
Figure 5-47 Removing a door status sensor
Step 4 Install a new door status sensor.
Step 5 Install the new door status sensor by performing the steps above in reverse order.
Step 6 Check whether the new door status sensor works properly. If the status
information of the door status sensor is displayed on the main screen of the
management system client after you open or close the corresponding cabinet
door, the new door status sensor works properly.
----End

5.4.3.7 Replacing a Cabinet Electronic Lock

Impact on the System
The electronic lock of the cabinet cannot be used.
Preparations
●
Procedure
Step 1 Open the cabinet door, and disconnect the monitoring cable from the electronic
lock.
Step 2 Remove the electronic lock.
Issue 01 (2020-12-25)
Material: electronic lock
Copyright © Huawei Technologies Co., Ltd.
5 Parts Replacement
96