Huawei FusionModule2000 Maintenance Manual page 105

FusionModule2000 Smart Modular Data Center
Maintenance Guide (Fusion Module Actuator)
● If the iBOX is damaged, hold down the networking switches on all the iBATs
● If the iBOX is not damaged, hold down the iBOX networking switch to clear
Step 2 Disconnect cables from the iBOX and label the cables.
1.
2.
3.
4.
Figure 5-49 Disconnecting cables from the iBOX
Step 3 Remove the iBOX.
Figure 5-50 Removing an iBOX (from a battery cabinet)
Figure 5-51 Removing an iBOX (from a battery rack)
Issue 01 (2020-12-25)
NO TICE
managed by the iBOX to clear present network parameters.
present network parameters.
Disconnect the cable from the PoE port.
Disconnect the cable (if there is any) from the COM port.
Disconnect the cable (if there is any) from the BCB port.
Disconnect the cable from the HALL current monitoring port.
Copyright © Huawei Technologies Co., Ltd.
5 Parts Replacement
98