Deselect Transformation (Trafoof) - Siemens SINUMERIK 840D sl Programming Manual

7.11

Deselect transformation (TRAFOOF)

7.11
Function
The TRAFOOF command disables all the active transformations and frames.
Note
Frames required after this must be activated by renewed programming.
Please note:
The same restrictions as for selection are applicable to deselecting the transformation (see
section "Constraints when selecting a transformation").
Programming
TRAFOOF
Parameters
TRAFOOF
Job planning
Programming Manual, 03/2006 Edition, 6FC5398-2BP10-1BA0
Disables all the active transformations/frames
7.11 Deselect transformation (TRAFOOF)
Transformations
7-77