Siemens SINUMERIK 840D sl Programming Manual page 640

Tables
15.1 List of statements
WALCS0
WORK-working area limitation
WALCS1 WORK-working-area-limitation group 1
WALCS2 WORK-working-area-limitation group 2
WALCS3 WORK-working-area-limitation group 3
WALCS4 WORK-working-area-limitation group 4
WALCS5 WORK-working-area-limitation group 5
WALCS6 WORK-working-area-limitation group 6
WALCS7 WORK-working-area-limitation group 7
WALCS8 WORK-working-area-limitation group 8
WALCS9 WORK-working-area-limitation group 9
WALCS10 WORK-working-area-limitation group 10
WALIMOF Working area limitation OFF
WALIMON Working area limitation ON
1
WHILE Start of WHILE program loop
WRITE Write block in file system. Appends a block
to the end of the specified file.
X Axis
XOR Logical exclusive OR
Y Axis
Z Axis
Legend:
Default setting at beginning of program (factory settings of the control, if nothing else programmed).
1
The groups are numbered according to the table in section "List of G functions/preparatory functions".
2
Absolute end points: modal; incremental end points: non-modal; otherwise modal/non-modal (m, n) depending on syntax
3
of G function.
As arc centers, IPO parameters act incrementally. They can be programmed in absolute mode with AC. The address
4
modification is ignored when the parameters have other meanings (e.g., thread pitch).
The keyword is not valid for SINUMERIK 810D
5
The keyword is not valid for SINUMERIK 810D/NCU571
6
The keyword is only valid for SINUMERIK FM-NC
7
The OEM can add two extra interpolation types. The names can be changed by the OEM.
8
Extended address notation cannot be used for these functions.
9
15-36
deselected
active
active
active
active
active
active
active
active
active
active
End: ENDWHILE
The blocks are
inserted after
M30
Real
Real
Real
Programming Manual, 03/2006 Edition, 6FC5398-2BP10-1BA0
; separate block
; separate block
m 60
m 60
m 60
m 60
m 60
m 60
m 60
m 60
m 60
m 60
m 60
m 28
m 28
m,n
3
m,n
3
m,n
3
Job planning