Tables; List Of Statements - Siemens SINUMERIK 840D sl Programming Manual

Tables

15.1

List of statements

15.1
The list of statements summarizes all programming commands and G codes available in the
job planning.
Legend:
Default setting at beginning of program (factory settings of the control, if nothing else programmed).
1
The groups are numbered according to the table in section "List of G functions/preparatory functions".
2
Absolute end points: modal; incremental end points: non-modal; otherwise modal/non-modal (m, n) depending on syntax
3
of G function.
As arc centers, IPO parameters act incrementally. They can be programmed in absolute mode with AC. The address
4
modification is ignored when the parameters have other meanings (e.g., thread pitch).
The keyword is not valid for SINUMERIK 810D
5
The keyword is not valid for SINUMERIK 810D/NCU571
6
The keyword is only valid for SINUMERIK FM-NC
7
The OEM can add two extra interpolation types. The names can be changed by the OEM.
8
Extended address notation cannot be used for these functions.
9
name Meaning
: Block number - main block (see N)
A Axis
A2 Tool orientation: Euler angles
5
Job planning
Programming Manual, 03/2006 Edition, 6FC5398-2BP10-1BA0
Value Description,
assignme comment
nt
0 ... Special
9999 identification of
9999 blocks rather
integers than N... ;this
only, block should
without contain all
leading statements for
signs a following
complete
machining
section
Real
Real
Syntax Modal/
non-
modal
e.g. :20
m,n
s
15
Group
2
3
15-1