Setting Parameters Before Using The Snmp Management - Huawei TP48200A-HX09A2 Installation Manual

TP48200A-HX09A2 & TBC300A-TCA2
Installation Guide
Main Menu Second-
Level Menu
Settings Parameters
----End

10.7.3 Setting Parameters Before Using the SNMP Management

Prerequisites
Before setting SNMP parameters, obtain the information listed in
Table 10-9 Information obtained from the NMS
Information
SNMP version
SNMP Port Number
Read Community Name
Write Community Name
User Name
MD5 Password
DES Password
Trap Target Address
Trap Port
Procedure
Step 1 Apply to the site or equipment room network administrator for a fixed IP address.
Step 2 Set the IP address, subnet mask, and gateway on the LCD, as shown in
Issue 01 (2013-10-25)
Third-Level Fourth-
Menu Level Menu
M/S Protocol Northbound
Description
SNMP version and port number used by the SMU and NMS. The SNMP
versions include SNMPv1, SNMPv2c, and SNMPv3.
If you use SNMPv1 or SNMPv2c, enter the read community name and write
community name that comply with the NMS. Otherwise, the SMU will not
connect to the NMS.
To enhance the security, you need a user name and password for
authentication if you use SNMPv3. After the authentication succeeds, the
SMU can communicate with the NMS.
IP address and port number reported in the alarm trap.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Fifth-Level Default
Menu Value
Protocol M/S Protocol
Type
Baud Rate 9600
Comm. 3
Address
Table 10-9
10 Commissioning
Setting
M/S Protocol
9600
3
from the NMS.
Table 10-10.
86