Mitsubishi Electric 800 Series Instruction Manual page 265

• When Pr.495 = "10 or 11", the remote output data in the signal before the reset is stored even during an inverter reset.
ON/OFF example for positive logic
Pr.495 = 0, 10
Power
OFF
supply
REM
REM signal clear
Signal condition during a reset
Pr.495 = 0, 1
ON
Reset
REM ON
∗
∗ When Pr.495 = "1", the signal condition saved in EEPROM
(condition of the last power OFF) is applied.
NOTE
• The output terminal to which the REM signal is not assigned by using Pr.190 to Pr.192 does not turn ON or OFF when "1 or
0" is set in bit corresponding to each of the terminals by using Pr.496 and Pr.497. (ON/OFF command affects only the terminal
to which the REM signal is assigned.)
• If the power supply is turned OFF during an inverter reset, the remote output data is not stored even when Pr.495 = "1 or 11".
Parameters referred to
Pr.190 to Pr.196 (Output terminal function
264
11. (M) Item and Output Signal for Monitoring
11.10 Remote output function
Inverter
reset time
Pr.495 = 1, 11
(about 1s)
Power
OFF
supply
OFF ON
REM
REM signal held
REM signal is saved
Pr.495 = 10, 11
ON
Reset
OFF REM
ON
selection)page 250