Mitsubishi Electric 800 Series Instruction Manual page 378

NOTE
• When the Advanced magnetic flux vector control, Real sensorless vector control, or PM sensorless vector control is selected,
Pr.3, Pr.47, and Pr.19 are disabled, and Pr.83 and Pr.84 are enabled.
However, S-pattern curve with Pr.29 Acceleration/deceleration pattern selection = "1" (S-pattern acceleration/deceleration
A) enables Pr.3 or Pr.47. (S-pattern curve under PM sensorless vector control is the rated frequency of the motor.)
• Changing the terminal assignment using Pr.178 to Pr.189 (Input terminal function selection) may affect the other functions.
Set parameters after confirming the function of each terminal.
Parameters referred to
Pr.14 Load pattern selectionpage 378
Pr.29 Acceleration/deceleration pattern
Pr.83 Rated motor voltage, Pr.84 Rated motor
Pr.178 to Pr.189 (Input terminal function
selectionpage 163
frequencypage 378
selection)page 283
377
15. (G) Control Parameters
15.2 Base frequency voltage
11
12
13
14
15
16
17
18
19
20