Code Model Parameter - Panasonic IMAGECHECKER PV230 Manual

3.3.2 Code Model Parameter

Bar Code
1.
Select a bar code type in "Code Type".
2.
Select "Manual" in "Code Model Parameter".
The "Code Model Parameter" for bar codes is
"Manual" only.
3.
Various conditions are displayed. Change them if
necessary.
As the widths of bars and spaces composing
codes differ depending on code types, the defaults
of parameters differ depending on code types.
Parameter item
Element Height
Min.
Code Orientation
68
Settable range Description
-1, 8 to 200 Min. value of the height of a bar code (unit: pixel)
By specifying "-1", the height is automatically detected and
the code is read. It should be set to read codes which are
extremely higher or lower than standard codes
Default: -1
-90.0 to 90.0 Specify the orientation of a bar code in degrees. (unit: degree)
When Rotation Adjustment or Calibration is not used, X axis is
0 degree and clockwise is positive angle.
When the coordinate conversion by calibration is executed,
the X axis after the conversion is 0 degree.
If it follows Position/Rotation Adjustment, the adjusted angle
is 0 degree.
Default: 0.0