Siemens SINUMERIK 840D sl Function Manual page 324

Manual and Handwheel Travel (H1)
Start-up: Handwheels
4.9.2 Connection via cable distributor
Parameter setting
Parameterization of handwheels connected via cable distributor is done via the following
NCK machine data:
● MD11350 $MN_HANDWHEEL_SEGMENT[<
● MD11351 $MN_HANDWHEEL_MODULE[<
● MD11352 $MN_HANDWHEEL_INPUT[<
Example
Direct connection of 2 handwheels via a cable distributor.
Parameter setting:
Machine data
MD11350 $MN_HANDWHEEL_SEGMENT[0]
MD11351 $MN_HANDWHEEL_MODULE[0]
MD11352 $MN_HANDWHEEL_INPUT[0]
MD11350 $MN_HANDWHEEL_SEGMENT[1]
MD11351 $MN_HANDWHEEL_MODULE[1]
MD11352 $MN_HANDWHEEL_INPUT[1]
References
● SINUMERIK 840D
● SINUMERIK 840Di
324
When connected via cable distributor, the hardware segment has always to be entered as 1
(local hardware segment).
When connected via cable distributor, the hardware module has always to be entered as 1.
connection
>
Handwheel connection used: 1 or 2
Note
A maximum of two handwheels can be connected via the cable distributor.
/PHD/ NCU Configuration Manual
Chapter: Cable distributor (distributor box)
/HBI/ Manual, SINUMERIK 840Di
chapter: Hardware Descriptions > Cable distributor
Handwheel_No._in_NCK - 1
Handwheel_No._in_NCK - 1
Handwheel_No_in_NCK - 1
Value Description
1st handwheel:
1 Connection via cable distributor always 1
1 Connection via cable distributor always 1
1 1. Handwheel connection at cable distributor
2nd handwheel:
1 Connection via cable distributor always 1
1 Connection via cable distributor always 1
2 2. Handwheel connection at cable distributor
Function Manual, 03/2009, 6FC5397-1BP10-4BA0
>] = 1
>] = 1
Handwheel
>] = <
Extended Functions