Mitsubishi Electric MELSEC iQ-R Series User Manual page 169

Buffer memory name
CH User range setting thermoelectromotive force
offset value (H) (in Q compatible mode)
(for the thermocouple input module)
CH User range setting offset resistance value (H)
(in Q compatible mode)
(for the RTD input module)
CH User range setting thermoelectromotive force
gain value (L) (in Q compatible mode)
(for the thermocouple input module)
CH User range setting gain resistance value (L)
(in Q compatible mode)
(for the RTD input module)
CH User range setting thermoelectromotive force
gain value (H) (in Q compatible mode)
(for the thermocouple input module)
CH User range setting gain resistance value (H)
(in Q compatible mode)
(for the RTD input module)
When the following operations are performed, the data to be used is stored (saved).
• Writing the initial setting by engineering tool
• Turning off and on 'Operating condition setting request' (Y9) (Data is not saved when the mode is switched from the normal
mode to the offset/gain setting mode by the mode switching setting.)
• Writing an offset/gain value in the offset/gain setting mode (When 'User range write request' (YA) is turned off and on)
To restore offset/gain set values in the user range setting, set the data so that data saved in this area is the same as that of
the corresponding area of the temperature input module of the restore destination.
■Default value
The default value is 0 for all the channels.
CH1 CH2 CH3
199 211 223
200 212 224
201 213 225
CH4 CH5 CH6
235 247 259
236 248 260
237 249 261
Appendix 3 Buffer Memory Areas
CH7 CH8
271 283
272 284
273 285
A
APPX
167