Mitsubishi Electric MELSEC iQ-R Series User Manual page 142

• Set a primary delay filter constant for the primary delay filter. The value of the time constant (ms) is the
product of the primary delay filter constant and the sampling cycle.
• Since the default value is 0, change the setting value according to the processing method.
• The setting for this area is ignored in the channel where Sampling processing (0) is set to 'CH1 Averaging
process specification' (Un\G501).
CH1 Alert output setting (Process alarm)
Set whether to enable or disable the alert output of the process alarm.
For details on the alert output function, refer to the following.
Page 27 Alert Output Function
Setting value
0
1
Setting a value other than the above causes an alert output setting (Process alarm) range error (error code: 1B0H).
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Alert output setting (Process alarm)
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9) to enable the setting.
■Default value
The default value is Disable (1) for all the channels.
APPX
140
Appendix 3 Buffer Memory Areas
Setting content
Enable
Disable
CH1 CH2 CH3
512 712 912
CH4 CH5 CH6
1112 1312 1512
CH7 CH8
1712 1912