Mitsubishi Electric MELSEC iQ-R Series User Manual page 151

Conversion setting at disconnection detection [Q compatible mode]
Set what value is to be stored in 'CH1 Measured temperature value' (Un\G11) at the time of disconnection detection with the
Q compatible mode function used.
b15 ... b12 b11 ...
(1)
CH4 CH3
b15 ... b12 b11 ...
(2)
CH8 CH7
(1) Conversion setting at disconnection detection (Un\G164) (setting range CH1 to CH4)
(2) Conversion setting at disconnection detection (Un\G165) (setting range CH5 to Ch8)
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Conversion setting at disconnection detection
The setting values are the same as those of R mode.
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9) to enable the setting.
■Default value
The default value is Downscale (1) for all the channels.
CH1 Conversion setting value at disconnection detection
When 'CH1 Conversion setting at disconnection detection' (Un\G531) is set to Any value (2), the value set in this area is
stored in 'CH1 Measured temperature value' (Un\G400) at the time of disconnection detection.
For details on the disconnection detection function, refer to the following.
Page 34 Disconnection Detection Function
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Conversion setting value at disconnection
detection
CH Conversion setting value at disconnection
detection (in Q compatible mode)
■Setting range
The possible range is from -32768 to 32767 (-3276.8 to 3276.7). (can be set in a unit of 0.1)
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9) to enable the setting.
■Default value
The default value is 0 for all the channels.
b8 b7 ... b4 b3 ...
CH2 CH1
b8 b7 ... b4 b3 ...
CH6 CH5
CH1 CH2 CH3
164
CH1 CH2 CH3
532 732 932
166 167 168
b0
b0
CH4 CH5 CH6
165
CH4 CH5 CH6
1132 1332 1532
169 170 171
Appendix 3 Buffer Memory Areas
CH7 CH8
A
CH7 CH8
1732 1932
172 173
APPX
149