Parameterization; Set Parameters (Setup) - Siemens SENTRON 7KT PAC1600 Equipment Manual

Description
3.5 Three-phase devices 5 A
3.5.4

Parameterization

3.5.4.1

Set parameters (setup)

Selecting a menu
1. In the standard measurement display, simultaneously press the "Increase" and "Decrease"
keys to call the main menu.
2. Select SET and press the "Next" key to open the settings menu.
The display shows the first menu level P01 on the top left with selection 01 flashing.
3. Use the "Increase" or "Decrease" keys to select the required menu (e.g. P01, P02, P03).
During the selection, the alphanumeric display shows a brief description of the currently
selected menu.
Simultaneously press the "Increase" and "Decrease" keys to exit the setting and return to
the measurement display.
Note
The following table lists the available menus, which vary depending on the device
versions. Not all codes are available with all devices.
1)
2)
48
Code Menu
P01 GENERAL
P02 OTHER
P03 PASSWORD
P04 INTEGRATION
P05 HOUR COUNTER
P07 COMMUNICATION
P08 LIMIT THRESHOLDS
P09 ALARMS
P11 ENERGY PULSES
P13 INPUTS
P14 OUTPUTS
2)
On M-BUS and RS 485 devices only
On S0 devices only
Description
Specification of the system
Language, brightness, display, etc.
Password activation
Integration times
Hour counter settings
Communication settings
1)
Limit values
Alarm messages
Configuration of energy pulses (S0)
2)
Programmable inputs
Programmable outputs
7KT16 energy meter
Equipment Manual, 09/2020, 2514284147-04