Alarm Display - Siemens SENTRON 7KT PAC1600 Equipment Manual

3.5.4.6

Alarm display

If alarms are activated, the device displays the page with the corresponding status and the
following format:
①
②
③
④
You can find more information on parameter P09 in chapter Parameter table (Page 54).
• If the alarm is activated, the word ON flashes with the triangle symbol. If the alarm is not
activated, the word OFF is displayed continuously.
• If no alarm is programmed, dashes are displayed. After approx. 3 s, the scrolling text for
the alarm programmed in parameter P09.n.05 appears.
• If several alarms are active, the texts are displayed in succession.
• You can use parameter P02.14 for the Other menu to make the backlighting of the display
flash in the event of an alarm and to make it more obvious that a fault has occurred.
• The alarm reset method depends on parameter P09.n.03. The parameter determines
whether it is defined automatically or manually via the command menu (parameter C.07)
if alarm conditions are not fulfilled. You can find more information in chapter Command
menu (Page 64).
7KT16 energy meter
Equipment Manual, 09/2020, 2514284147-04
Alarm 2 activated/deactivated
Alarm text activated
Alarm code activated
Alarm 1 activated/deactivated
Description
3.5 Three-phase devices 5 A
53