Siemens SENTRON 7KT PAC1600 Equipment Manual page 91

Address Number
of regis-
Hex Decimal
ters
4F00 20224 1
4F01 20225 1
4F02 20226 1
4F04 20227 1
Modbus command parameter
Modbus measured variables with the function code 06
Address Number
of regis-
Hex Decimal
ters
2FF0 12272 1
2FF1 12273 1
Range limit
4200 16896 1
After executing this command, it is recommended that you issue the REBOOT command.
1)
After executing this command, you can use the query under address 0x1F20 to obtain the test result. The assignments
2)
of the reply bit are shown in the wiring test results table below.
This function is only active if none of the inputs is assigned the tariff function (TAR-A and TAR-B).
3)
7KT16 energy meter
Equipment Manual, 09/2020, 2514284147-04
Format Access Unit
UINT16 R BOOL
UINT16 R BOOL
UINT16 R BOOL
UINT16 R BOOL
Format Access Unit
UINT16 W 0
UINT16 W 1
UINT16 W 2
UINT16 W 3
UINT16 W 4
UINT16 W 5
UINT16 W 6
UINT16 W 7
UINT16 W 11
UINT16 W 12
UINT16 W 13
UINT16 W 14
UINT16 W 15
UINT16 W 16
UINT16 W 100
UINT16 W 200
UINT16 W 1
UINT16 W 1, 2
6.4 Modbus address register
Factor Measured variable
– Remote 1
– Remote 2
– Remote 3
– Remote 4
Factor Measured variable
– Reset max & min values
– Reset max demand values
– Reset partial energy counter
– Reset partial operating hours counter
– Reset external counters
– Reset energy tariffs
– Reset alarms
– Reset limits
– Reset total energy
– Reset all operating hours counters
– Reset parameters to factory default
– Backup all parameters
– Restore all parameters
– Wiring test
2)
– Reset maximum values
– Reset minimum values
– System restart
– Set active energy tariff
Commissioning
1)
1)
1)
3)
89