• When the regenerative brake transistor is damaged, install a thermal relay to prevent overheat and burnout of the brake
resistor. (Refer to the Instruction Manual (Connection) to install a thermal relay.) Properly select a thermal relay according
to the regenerative driving frequency or the rated power or resistance of the brake resistor.
CAUTION
• If the resistor selection is incorrect, overcurrent may damage the inverter built-in brake transistor. Besides, the resistor
may be burned due to overheat.
• If the selection of the thermal relay is incorrect, the resistor may be burned due to overheat.
Parameters referred to
Pr.57 Restart coasting
timepage
Pr.178 to Pr.189 (Input terminal function
Pr.190 to Pr.196 (Output terminal function
488
17. (G) Control Parameters
17.8 Regenerative brake selection
443,
page 449
selection)page 368
selection)page 332