Siemens SIMATIC RF600 Series System Manual page 405

"ER" XML/ S7 block
LED LED (hex)
(hex)
-- 0xCC 0xE4FE8C
2 Hz 0xCD 0xE4FE8D
2 Hz 0xCE 0xE4FE8E
2 Hz 0x51 0xE5FE01
-- 0x52 0xE5FE02
2 Hz 0x54 0xE5FE04
-- 0x55 0xE5FE05
2 Hz 0x56 0xE5FE06
-- 0x57 0xE5FE07
SIMATIC RF600
System Manual, 10/2016, J31069-D0171-U001-A19-7618
Error description
Communication error between Ident profile and communications module. Handshake
•
error.
– UDT of this communications module is overwritten by other program sections
– Check parameter settings of communications module in the UDT
– Check the Ident profile command that caused this error
– Start "INIT" after correcting the error
Backplane bus / PROFIBUS DP / PROFINET error occurred
•
This error is only indicated when access monitoring has been enabled in the
PROFIBUS configuration.
– Backplane bus / PROFIBUS DP / PROFINET bus connection was interrupted (wire
break on the bus; bus connector on the communications module was briefly un-
plugged)
– Backplane bus / PROFIBUS DP / PROFINET master no longer addressing commu-
nications module
– Execute "INIT"
– The communications module has detected a frame interruption on the bus. The
backplane bus, PROFIBUS or PROFINET may have been reconfigured (e.g. with
HW Config or TIA Portal)
Firmware error
•
Possible cause: The firmware update was not run completely.
Internal communications error of the communications module/reader
•
– Connector contact problem on the communications module / reader
– Hardware of the communications module / reader has a defect; → Send in communi-
cations module / reader for repair
– Start "INIT" after correcting the error
Internal monitoring error of the communications module/reader
•
– Program execution error on the communications module / reader
– Turn the power supply of the communications module/reader off and on again
– Start "INIT" after correcting the error
The current command was aborted by the "WRITE-CONFIG" ("INIT" or "SRESET") com-
mand for the bus connector was pulled.
Possible causes:
Communication with the transponder was aborted by "INIT".
•
This error can only be reported if there is an "INIT" or "SRESET".
•
Incorrect sequence number order (SN) on the reader/communications module.
Incorrect sequence number order (SN) in the Ident profile
Invalid data block number (DBN) on the reader/communications module
Invalid data block number (DBN) in the Ident profile
Invalid data block length (DBL) on the reader/communications module
Invalid data block length (DBL) in the Ident profile
9.2 RF650R/RF680R/RF685R error messages
System diagnostics
405