Siemens SIMATIC RF600 Series System Manual page 412

Accessories
10.1 Wide-range power supply unit for SIMATIC RF systems
NOTICE
Restriction to the approval of the wide-range power supply
Alterations to the SIMATIC RFID modules and devices as well as the use of SIMATIC RFID
components with third-party RFID devices are not permitted.
Failure to observe this requirement shall constitute a revocation of the radio equipment
approvals, CE approval and manufacturer's warranty. Furthermore, the compliance to any
salient safety specifications of VDE/DIN, IEC, EN, UL and CSA will not be guaranteed.
Safety notes for the US and Canada
The readers of the SIMATIC RF600 series may only be operated with the wide range power
supply unit for SIMATIC RF systems - as an optional component – or with power supply units
that are UL-listed in combination with the safety standards specified below:
● UL 60950-1 - Information Technology Equipment Safety - Part 1: General Requirements
● CSA C22.2 No. 60950 -1 - Safety of Information Technology Equipment
NOTICE
Warranty
The compliance of the SIMATIC RFID systems to the safety standards mentioned above
and the conditions in the UL approval will not be guaranteed if neither the wide-range
power supply unit for SIMATIC RF systems nor power supplies listed according to the
safety standards named are used.
10.1.5 Connecting
The wide-range power supply unit for SIMATIC RF systems is sold with a country-specific
power cable for EU, UK and US.
Follow the steps below to connect the wide-range power supply unit:
1. Connect the reader to the outputs of the wide-range power supply unit.
2. Connect the power cable to the primary input (PE) of the wide-range power supply unit.
3. Connect the power cable of the wide-range power supply unit to the power supply.
NOTICE
Plugging/pulling the power supply cable
It is only permissible to plug or pull the power cable when no voltage is applied (powered-
down)
412
System Manual, 10/2016, J31069-D0171-U001-A19-7618
SIMATIC RF600