Huawei SmartAX MA5600T Hardware Description page 122

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Hardware Description
NOTE
Table 2-22
Table 2-22 Settings of SW2
DIP Switch
SW2-1
SW2-2
SW2-3
SW2-4
SW2-5
Issue 24 (2018-07-30)
describes the settings of SW2.
Indication
It is used to set the subnode address of the
fan tray that maps the data configuration.
l ON: The address bit is 0.
l OFF: The address bit is 1.
By default, the address bit is 1.
ON The baud rate of the
communication between the fan
tray and the control board is 19200
bit/s.
OFF The baud rate of the
communication between the fan
tray and the control board is 9600
bit/s.
It is used to set the quantity of fans.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Subrack and Chassis
Default Settings
OFF
ON
ON
ON
ON
102