Huawei SmartAX MA5600T Hardware Description page 232

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Hardware Description
Issue 24 (2018-07-30)
The H801SCUF control board supports the GICK board (an upstream board
n
with two GE ports), but only the first GE port on the GICK board is available.
In addition, the GICK board must be a version released later than April 2010.
The H801SCUF control board does not support the X2CA board.
n
– Either the four GE ports in the first upstream slot or the GE ports on the H801SCUF
control board can be selected through the electronic switch for upstream
transmission.
On the MA5600T, when the GICD/GICE/GSCA/GICK board is configured in
n
slot 19, the GE ports on these boards cannot be used together with GE Front
Panel Port of the H801SCUF control board. For the 10GE upstream board
such as X1CA, there is no such restriction. That is, the 10GE ports on these
boards can be used together with the GE Front Panel Port of the H801SCUF
control board.
On the MA5603T, when the GICD/GICE/GSCA/GICK board is configured in
n
slot 8, the GE ports on these boards cannot be used together with the GE Front
Panel Port of the SCUF control board. For the 10GE upstream board such as
X1CA, there is no such restriction. That is, the 10GE ports on these boards can
be used together with the GE Front Panel Port of the SCUF control board.
– Either the last of the four GE ports in the second upstream slot or the daughter
board attached to the SCUF control board can be selected through the electronic
switch.
On the MA5600T, when the GICD/GICE/GSCA board is configured in slot
n
20, the fourth GE port on these boards cannot be used together with the
daughter board attached to the SCUF control board. When the GICK board is
configured in slot 20, only the first GE port on the GICK board is available.
For the 10GE upstream board such as X1CA there is no such restriction. That
is, the 10GE ports on these boards can be used together with the daughter
board attached to the SCUF control board.
On the MA5603T, when the GICD/GICE/GSCA board is configured in slot 9,
n
the fourth GE port on these boards cannot be used together with the daughter
board attached to the SCUF control board. When the GICK board is
configured in slot 20, only the first GE port on the GICK board is available.
For the 10GE upstream board such as X1CA, there is no such restriction. That
is, the 10GE ports on these boards can be used together with the daughter
board attached to the SCUF control board.
– Reserves two 10GE channels (not available currently) for the MPLS daughter
board.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Board
212