Huawei FusionModule1000A40 Maintenance Manual page 26

FusionModule1000A40 Prefabricated All-in-One
Data Center
Maintenance Guide
Check Item Operation
RF_Z
indicator
AC actuator Power input
Power output
PWR
indicator
ALM
indicator
Issue 04 (2021-02-10)
Check Standard
On: No network
parameters exist. A
network is waiting to be
created.
Blinking slowly: A
network is set up, and
node access is not
allowed (the indicator
blinks at 0.5 Hz, on for
1s and then off for 1s).
Blinking at super short
intervals: A network is
set up, and node access
is allowed (the indicator
blinks at 10 Hz, on for
0.05s and then off for
0.05s).
Blinking at super short
intervals intermittently:
The device is searching
for a network (the
indicator blinks at 2 Hz,
on for 0.5s and then off
for 0.5s).
Input voltage: 90–240 V
AC
Output voltage: 90–240
V AC
Steady on: The power
supply is normal.
Off: No power supply is
available.
Steady on: A fault alarm
is generated.
Off: No fault alarm is
generated.
Copyright © Huawei Technologies Co., Ltd.
3 Routine Maintenance
Troubleshooting
For details, see the ECC800 documents.
Check the input power cables if the
input voltage is abnormal.
For details, contact Huawei technical
support.
Check the input power cables.
Clear the alarm by referring to the
ECC800 documents.
19