Huawei FusionModule1000A40 Maintenance Manual page 95

FusionModule1000A40 Prefabricated All-in-One
Data Center
Maintenance Guide
Skill requirement: ELV engineer
Procedure
Step 1 Remove the emergency door release button.
1.
2.
3.
4.
Figure 5-31 Removing an emergency door release button
Step 2 Install a new emergency door release button.
1.
2.
3.
4.
Figure 5-32 Installing an emergency door release button
Step 3 Check that the new emergency door release button is working properly.
Issue 04 (2021-02-10)
Remove screws securing the emergency door release button, as shown by (1)
in Figure 5-31.
Remove the glass panel of the emergency door release button, as shown by
(2) and (3) in Figure
Remove screws securing the base, as shown by (4) in
Disconnect cables and remove the emergency door release button.
Connect the cables.
Tighten screws on the base, as shown by (1) in
Install the glass panel, as shown by (2) and (3) in
Tighten screws, as shown by (4) in
Copyright © Huawei Technologies Co., Ltd.
5-31.
Figure 5-32.
5 Parts Replacement
Figure 5-31.
Figure 5-32.
Figure 5-32.
88