How To Change Settings; How To Restore The Original Factory Setting Of This Product - Panasonic YC-300BP2YAF Operating Instructions Manual

Operation

6.3.2 How to change settings

• Change these welding conditions as desired before use.
• As for any important welding conditions, store them in
the product by allocating the program numbers (See sec-
tion "Storing welding conditions.")
Set-value
LCD display
display
JOG dial
"FUNCTION" button

6.3.3 How to restore the original factory setting of this product

If you want to restore the original factory-setting, carry out
the operation indicated in the following table. (Underlined
bold character in the "LCD display" column indicates the
cursor position.)
• Hold down the JOG dial, and while holding it down,
1
turn on the "POWRE" switch.
• Press the JOG dial to determine the choice.
• *When you turn the JOG dial without pressing
2
down, the screen displays the next set item. In that
case, turn it further until the desired set item reap-
pears.
3 • Press the JOG dial.
4 • Turn the JOG dial and have "YES" displayed.
5 • Press the JOG dial
6 • Turn the JOG dial and have "YES" displayed.
7 • Press the JOG dial to complete.
34
1 Set "FUNCTION" button to "DETAIL."
Press the JOG dial until the set item
2
you want to change appears.
Turn the JOG dial until the required
3
set item appears.
4 Press the JOG dial.
Then, repeat the procedure from (2) through (4) until desired change of set
5
contents are completed.
6 Switch the "FUNCTION" button to "WELD" to start welding operation.
Operation
• As for welding condition not in store, the setting of the
product returns to the original factory-set welding condi-
tions when the factory setting is restored,.
Operation
First, "V Disp Status" appears on
the LCD display.
On "Set-value" display, set con-
tents is indicated.
Turn the JOG dial either clock-
wise or counter-clockwise.
The present set content is stored
and the next set item is displayed.
Note
If you get lost during the operation, turn the power off,
and repeat the same operations from item (1) again.
Set-value display
Remarks
LCD display
Rescue Menu
YC-300BP Series
Then indication changes to
1 Set Defaults?
No
1 Set Defaults?
No
(Cursor flashes.)
1 Set Defaults?
No
Are you sure?
* * * *
(Cursor flashes.)
Welding Current
OMCTT5639E09