Configuration; When Using The Special Air-Cooling Torch; When Using The Special Water-Cooling Torch - Panasonic YC-300BP2YAF Operating Instructions Manual

3.4 Configuration

• Customers are required to prepare the items other than
marked as "This product" or "Accessory".
• The items marked with "*" are available as peripheral
equipment (optional items), with separate sales. (See
section "Peripheral equipment").
3.4.1 When using the special air-cooling
torch
1
12
11
10
9
8
No. Item
(Common)
1 Welding power source
2 Argon gas regulator
3 Argon gas
4 Gas hose
5 Grounding wire
*1
6
Gas hose
7a
Air-cooling TIG welding torch
7b
Water-cooling TIG welding torch
8 Base metal
9 Remote controller
*3
10
Fingertip joint
11 Input power cable
12 Distribution box
OMCTT5639E09
3.4.2 When using the special water-cooling
2
3
5
4
6
7a
8
5
Remarks No.
(For water-cooling torch)
This product 13
14
15
Accessory
16
*1
*2
*2
*2
*3
*4
Accessory
• Cable for the base metal side:
To prevent overheat of the cable and provide with proper
welding, prepare a cable which is a welding cable or
cabtire cable (excluding the class-1 cabtire cable and vinyl
cabtire cable) of 38mm2 or more.
torch
1
12
11
10
9
Item
Supply water hose
Return water hose
Flow-rate switch cable
Cooling water unit and cooling
*4
water
The gas hose lead-out point of the air-cooling TIG welding
torch is different from that of the water-cooling TIG
welding torch.
In the case of arc spot welding, use the special arc spot
nozzle.
Connect it to the output cable of the base metal.
Do not put the cooling water system on top of the welding
power unit.
Installation
2 3
5
4
6
7b
5
Remarks
Accessory of
cooling water
unit.
13