Memory Lock; Setting And Checking Welding Conditions - Panasonic YC-300BP2YAF Operating Instructions Manual

Operation

6.3.5 Memory lock

While this product is capable of storing up to 50 welding
conditions (P01 to P50), if it is not desired for anybody
• Hold down the JOG dial, and while holding it down,
1
turn on the "POWRE" switch.
• Turn the JOG dial until the screen on the right
2
appears.
3 • Press the JOG dial.
4 • Turn the JOG dial and have "YES" displayed.
5 • Press the JOG dial.
6 • Turn the JOG dial and have "YES" displayed.
7 • Turn off the power to complete the operation.

6.3.6 Setting and checking welding conditions

After trial of welding, if you want to have higher welding
quality and performance, try to change the factory-set con-
dition as shown in page 9-1 to suit such a welding condition
as desired.
(Button location)
MODE
CRATER
AC WAVE
36
Operation
• Set "FUNCTION" button to
1
"WELD."
• With "MODE" button, select a
2
desired weld method.
• <In case of "AC TIG" mode>
á
• With "AC WAVE"
select a desired wave type.
• With
4 select a crater type or "ARC
SPOT".
"FUNCTION"
other than the administrator to conduct the storing opera-
tion, lock the stored memory in the following manner.
Set-value display
[To keep a note of the result after change, make use of the
"Welding condition memorandum" (Appendix).]
Operation
When the arc spot welding is desired:
Choose "DC" or "AC".
button,
When the arc spot welding is desired,
"CRATER" button",
select "ARC SPOT".
Otherwise, (no arc spot), select crater
control "OFF", "ON" or "REPEAT".
LCD display
Rescue Menu
YC-300BP Series
Then indication changes to
1 Set Defaults?
No
3 Lock Memory?
No
3 Lock Memory?
No
3 Lock Memory?
Yes
Remarks
OMCTT5639E09