Siemens SIMEAS R-PMU Manual page 66

7
7.2 Fault Recorders
Quality tracks (binary tracks)
All tracks including quality tracks are recorded by SIMEAS R-PMU, evaluated by OSCOP P and
presented in the form of a diagram with eight tracks (one track not used). Depending on the
status, a bar (logical 1) or no bar (logical 0) is recorded.
The following status information is displayed for the recording period of time that is set on
OSCOP P:
Reference frequency invalid: The reference is invalid (insufficient signal quality), the
measured values based on the reference frequency are also invalid.
0: Reference frequency valid
1: Reference frequency invalid
Frequency group 1 invalid: The frequency measurement of group 1 of the evaluated DAU
is not possible or faulty, e. g., because of missing signals.
0: Frequency measurement valid
1: Frequency measurement invalid
Frequency group 2 invalid: The frequency measurement of group 2 of the evaluated DAU
is not possible or faulty, e. g., because of missing signals.
0: Frequency measurement valid
1: Frequency measurement invalid
DAU not synchronized: Synchronization of the evaluated DAU is not (yet) possible
because, for example, the system has not (yet) completed the transient recovery phase after
the GPS signal has been cut-off and returned, or after the SIMEAS R has been restarted.
0: Time synchronized in DAU
1: Time not synchronized in DAU
CPU not synchronized: The CPU is not or not yet synchronized and is thus free-running
based on RTC (DCF77 signal provided only approx. 2 minutes after start-up).
0: Time synchronized in CPU
1: Time not synchronized in CPU
TAR recording active: displays the current recording of the TAR
0: inactive: no recording
1: active: recording active
TPR recording active: displays the current recording of the TPR
0: inactive: no recording
1: active: recording active
66
Digital Fault Recorder, SIMEAS R-PMU, Manual
E50417-H1076-C360-A5, Release 10.2012