Crankshaft Removal / Inspection - Polaris RZR XP 1000 2014 Service Manual

ENGINE / COOLING SYSTEM
5. Measure each bearing journal in two locations, 90
degrees apart. Replace balance shaft if either journal
is worn below the service limit specification. If worn
past the service limit, replace the balance shaft
assembly.
MEASUREMENT
Balance Shaft Diameter (MAG & PTO):
1.4939 - 1.4946" (37.946 - 37.962 mm)
Service Limit:
1.4921" (37.900 mm)
3.54

CRANKSHAFT REMOVAL / INSPECTION

1. Perform Crankcase Disassembly / Inspection, page
3.51 procedure.
2. Perform Balance Shaft Removal / Inspection, page
3.53 procedure.
3. For ease of assembly, mark each connecting rod and
end cap.
4. Loosen, remove and discard the four connecting rod
q
bolts . Remove the end caps from the crankshaft.
5. Carefully lift the crankshaft
6. Remove the cam chain
r
and PTO main seal
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
w
out of the crankcase.
e
, oil pump drive chain
from the crankshaft.
© Copyright Polaris Industries Inc.
t