Belt Inspection; Belt Installation; Pvt Break-In (Drive Belt / Clutches) - Polaris RZR XP 1000 2014 Service Manual

PVT SYSTEM

BELT INSPECTION

1. Inspect belt for hour glassing (extreme circular wear
in at least one spot and on both sides of the belt).
Hour glassing occurs when the drive train does not
move and the drive clutch engages the belt.
2. Inspect belt for loose cords, missing cogs, cracks,
abrasions, thin spots, or excessive wear. Compare
belt measurements with a new drive belt. Replace if
necessary.
3. Belts with thin spots, burn marks, etc., should be
replaced to eliminate noise, vibration, or erratic PVT
operation. See the Troubleshooting Chart at the end
of this chapter for possible causes.

BELT INSTALLATION

Be sure to install belt in the same direction as it was
removed.
1. With the clutch spreader tool installed
or 2878925), loop the belt over the drive clutch and
over the driven clutch.
2. Rotate the driven clutch and walk the belt into the
clutch.
3. Remove the clutch spreader tool from driven clutch
4. Rotate / spin the driven clutch and belt approximately
5-7 times to properly seat the belt in the driven
clutch.
5. Install the outer clutch cover and eight screws.
Torque screws to specification.
TORQUE
Outer Clutch Cover Retaining Screws:
48 in-lb (5 Nm)
5.18
NOTE
w
(2877408

PVT BREAK-IN (DRIVE BELT / CLUTCHES)

A proper break-in of the clutches and drive belt will
ensure a longer life and better performance. Break in the
clutches and drive belt by operating at slower speeds
during the 10 hour break-in period as recommended (see
Chapter 3 – Engine Break-In Period, page 3.35 for
break-in example). Pull only light loads. Avoid aggressive
acceleration and high speed operation during the break-
in period.
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.